McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

Set Config Security Portbinding command

Description Configures a list of device WWNs that are permitted to log in to a port. The changes you make with

this command are not retained when you reset or power cycle the switch unless you save them using

the Config Save command.

Authority Admin session and a Config Edit session

Syntax

set config security portbinding [port_number]

Operands

[port_number]

Initiates an editing session in which to change the port binding configuration for the port given

by [port_number]. The system displays each parameter one line at a time and prompts you

for a value. For each parameter, enter a new value or press Enter to accept the current value

shown in brackets. Enter q or Q to end the editing session. Table 21 describes the

Set Config Security Portbinding parameters.

Table 21 Set Config Security Portbinding parameters

Parameter Description

PortBindingEnabled Enables (True) or disables (False) port binding for the port given by

[port_number].

WWN WWN for the port/device that is allowed to connect to the port given

by [port_number].

Examples The following is an example of the Set Config Security Portbinding command:

McDATA4GbSAN #> admin start

McDATA4GbSAN (admin) config edit

McDATA4GbSAN (admin-config) #> set config security portbinding 0

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate this process before reaching the end of the list

press 'q' or 'Q' and the ENTER key to do so.

PortBindingEnabled (True / False)[False] true

WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9

WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8

WWN (N=None / WWN)[None ]

Finished configuring attributes.

This configuration must be saved (see config save command) and

activated (see config activate command) before it can take effect.

To discard this configuration use the config cancel command