McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 133
Enter the Show Config Switch command to display switch configuration values.
switch
Resets the switch without a POST. This is the default. This reset disrupts traffic and does the
following:
• Activates the pending firmware
• Closes all management sessions
• Clears the event log. To save the event log before resetting, see the Set Log command
To reset the switch with a POST, see the Hardreset command. To reset the switch without
disrupting traffic, see the Hotreset command.
system
Resets the system configuration settings to the factory default values. See Table 17 for system
configuration default values.
NOTE: Because the system operand changes network parameters, the workstation could
lose communication with the switch and release the Admin session.
This operand does not affect installed PFE keys.
zoning
Clears the zoning database and deactivates the active zone set. The zoning configuration values
(InteropAutosave/DefaultZone) remain unchanged.
Notes The following tables specify the factory default settings.
Table 10 Switch configuration defaults
Parameter Default
Admin State Online
Broadcast Enabled True
InbandEnabled True
FDMIEnabled True
FDMIEntries 1000
DefaultDomain ID 97 (0x Hex)
Domain ID Lock False
Symbolic Name McDATA4GbSAN
R_A_TOV 10000
E_D_TOV 2000
Principal Priority 254
Configuration Description Default Config
InteropMode Standard
239DomainSupport False