McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

132
Reset command
Description Resets the switch configuration parameters. If you omit the operand, the default is Reset Switch.
Authority Admin session
Syntax
reset
config [config_name]
factory
port [port_number]
radius
security
services
snmp
switch (default)
system
zoning
Operands
config [config_name]
Resets the configuration given by [config_name] to the factory default values for switch, port,
port threshold alarm, and zoning configuration as described in Table 10 through Table 13. If
[config_name] does not exist on the switch, a configuration with that name will be created. If
you omit [config_name], the active configuration is reset. You must activate the configuration
for the changes to take effect for switch, port, and port threshold alarm configuration default
values.
factory
Resets switch configuration, port configuration, port threshold alarm configuration, zoning
configuration, SNMP configuration, RADIUS configuration, switch services configuration, system
configuration, and security configuration to the factory default values as described in Table 10
through Table 18. The switch configuration is activated automatically.
NOTE: Because the factory operand changes network parameters, the workstation could
lose communication with the switch and release the Admin session.
This operand does not affect installed PFE keys.
port [port_number]
Re-initializes the port given by [port_number]. External ports are numbered 0 and 9; internal
ports are numbered 1–8.
radius
Resets the RADIUS configuration to the default values as described in Table 15.
security
Clears the security database and deactivates the active security set. The security configuration
value, autosave, and fabric binding remain unchanged.
services
Resets the switch services configuration to the default values as described in Table 16.
snmp
Resets the SNMP configuration settings to the factory default values. See Table 14 for SNMP
configuration default values.