McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem command line interface guide 123
Image command
Description Manages and installs switch firmware.
Authority Admin session
Syntax
image
cleanup
fetch [account_name] [ip_address] [file_source] [file_destination]
install
list
tftp [ip_address] [file_source] [file_destination]
unpack [file]
Operands
cleanup
Removes all firmware image files from the switch. All firmware image files are removed
automatically each time the switch is reset.
fetch [account_name] [ip_address] [file_source] [file_destination]
Retrieves image file given by [file_source] and stores it on the switch with the file name
given by [file_destination]. The image file is retrieved from the FTP server with the IP
address given by [ip_address] and an account name given by [account_name]. If an
account name needs a password to access the FTP server, the system will prompt you for it.
install
Downloads firmware from a remote host to the switch, installs the firmware, then resets the switch
(without a POST) to activate the firmware. The command prompts you for the following:
• File transfer protocol (FTP or TFTP)
• IP address of the remote host
• An account name and password on the remote host (FTP only)
• Pathname for the firmware image file
list
Displays the list of image files that reside on the switch.
tftp [ip_address] [file_source] [file_destination]
Retrieves image file given by [file_source] using TFTP and stores it on the switch with the file
name given by [file_destination]. The image file is retrieved from the host IP address
given by [Ip_address].
unpack [file]
Installs the firmware file given by [file]. After unpacking the file, a message appears
confirming successful unpacking. The switch must be reset for the new firmware to take effect.