McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

114
Secondary
Hash
Hash function to use to decipher the encrypted Secondary Secret sent by the ISL
group member. Hash values are MD5 or SHA-1. The Secondary Hash is used
when the Primary Hash is not available on the ISL group member. The Primary
Hash and the Secondary Hash cannot be the same.
NOTE: Secondary Hash is not supported when connecting to other
McDATA products.
Secondary
Secret
Hex string that is encrypted by the Secondary Hash and sent for authentication.
The string has the following lengths depending on the Secondary Hash function:
• MD5 hash: 16-byte
• SHA-1 hash: 20-byte
NOTE: Secondary Secret is not supported when connecting to other
McDATA products.
Binding Domain ID of the switch to which to bind the ISL group member WWN. This
option is available only if FabricBindingEnabled is set to True using the
Set Config Security command. 0 (zero) specifies no binding.
Table 6 ISL Group member attributes (Continued)
Attribute Description
Table 7 Port Group member attributes
Attribute Description
Member WWPN for the N_Port device that would attach to the switch. A member cannot
belong to more than one group.
Authentication Enables (CHAP) or disables (None) authentication using Challenge Handshake
Authentication Protocol. The default is None.
Primary Hash The preferred hash function to use to decipher the encrypted Primary Secret sent by
the Port group member. The hash functions are MD5 or SHA-1. If the Port group
member does not support the Primary Hash, the switch will use the Secondary
Hash.
Primary Secret Hexadecimal string that is encrypted by the Primary Hash for authentication with
the Port group member. The string has the following lengths, depending on the
Primary Hash function:
MD5 hash: 16-byte
SHA-1 hash: 20-byte