McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

110
Feature command
Description Adds Product Feature Enablement (PFE) key features to the switch and displays the PFE key log. A
PFE key is a password that you can purchase from your switch distributor or authorized reseller to
enable particular features in your switch.
Authority Admin session for Add operand only
Syntax
feature
add [pfe_key]
log
Operands
add [pfe_key]
Adds the feature that corresponds to the value given by [pfe_key]. [pfe_key] is case
insensitive.
log
Displays a list of installed PFE key features.
Notes To obtain the McDATA 4Gb SAN Switch serial number and PFE key, follow the step-by-step
instructions on the
firmware feature entitlement request certificate for the PFE key. You can obtain a
PFE key from the web at: www.webkey.external.hp.com
.
The following PFE keys are available:
• The SANtegrity™ Enhanced PFE key enables device security on the switch. Device security
commands include the following:
• Group command
• Security command
• Securityset command
• Set Config Security command
• Set Config Security Switchbinding command
• The Element Manager PFE key enables Element Manager for use through HAFM or EFCM.
If the PFE key instructions indicate that the procedure is disruptive, isolate the switch from the fabric
before installing the PFE key.
See also Group command, page 113
Security command, page 139
Securityset command, page 142
Set Config Security command, page 149
Set Config Security Switchbinding command, page 151