McDATA® 4Gb SAN Switch for HP p-Class BladeSystem Command Line Interface Guide (AA-RWEJA-TE, November 2006)

100
Config command
Description Manages the FC configurations on a switch. For information about setting the port and switch
configurations, see the Set Config Switch command.
Authority Admin session for all operands except List.
Syntax
config
act
ivate [config_name]
backup
cancel
copy [config_source] [config_destination]
del
ete [config_name]
edit [config_name]
list
restore
save [config_name]
Operands
activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the currently
active configuration is used. Only one configuration can be active at a time.
backup
Creates a file named configdata, which contains the system configuration information. This
operand does not require an admin session.
cancel
Terminates the current Config Edit session without saving changes that were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the default
configuration.
delete [config_name]
Deletes the configuration given by [config_name] from the switch. You cannot delete the
default configuration (Default Config) nor the active configuration.
edit [config_name]
Begins an edit session for the configuration given by [config_name]. If you omit
[config_name], the currently active configuration is used.
list
Displays a list of all available configurations on the switch. This operand does not require an
Admin session.