Maintenance and Service Guide
Table Of Contents
- Product features
- Illustrated parts catalog
- Routine care, SATA drive guidelines, and disassembly preparation
- Removal and replacement procedures
- Computer Setup (F10) Utility
- Using HP PC Hardware Diagnostics
- Troubleshooting without diagnostics
- Safety and comfort
- Before you call for technical support
- Helpful hints
- Solving general problems
- Solving power problems
- Solving hard drive problems
- Solving audio problems
- Solving printer problems
- Solving keyboard and mouse problems
- Solving hardware installation problems
- Solving network problems
- Solving memory problems
- Solving USB flash drive problems
- Solving Internet access problems
- Solving software problems
- Backing up, restoring, and recovering
- POST error messages and diagnostic front panel LEDs and audible codes
- Password security and resetting CMOS
- Power cord set requirements
- Statement of memory volatility
- Specifications
- Index
Table 5-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
Increase Idle Fan Speed(%)
Sets idle fan speed percentage. This setting only changes the minimum fan speed. The fan is still
automatically controlled.
M.2 USB/Bluetooth
Select to enable the M.2 controller. Default is enabled.
LAN/WLAN auto switching
Select to enable auto switching between a wired and wireless connection. Default is disabled.
Wake on WLAN
Select to enable wake on WLAN. Default is disabled.
Collaboration Buttons
Clear to disable the collaboration buttons. Default is enabled.
Button Sensitivity
Select from low, medium, or high. Default is low.
Port Options Rear USB ports
Lets you disable the ports. Default is enabled.
Right USB ports
Lets you disable the ports. Default is enabled.
USB Legacy Port Charging
Lets you enable USB charging port capability when the computer is in hibernate or shutdown mode.
Default is enabled.
USB Type-C Downstream Charging
Lets you enable USB charging port capability when the computer is in hibernate or shutdown mode.
Default is enabled.
Thunderbolt Type-C Ports
Lets you disable the ports. Default is enabled.
Thunderbolt Mode
Default is enabled.
Require BIOS PW to change Thunderbolt Security Level
Default is enabled.
Thunderbolt Security Level
Default is PCIe and DisplayPort - User Authorization.
Native PCIe Hot Plug
When enabled, Thunderbolt S4 Boot is disabled. Default is enabled.
SATA0
Lets you disable the connector. Default is enabled.
Restrict USB Devices
58 Chapter 5 Computer Setup (F10) Utility