Maintenance and Service Guide
Table Of Contents
- Product features
- Illustrated parts catalog
- Routine care, SATA drive guidelines, and disassembly preparation
- Removal and replacement procedures
- Computer Setup (F10) Utility
- Using HP PC Hardware Diagnostics
- Troubleshooting without diagnostics
- Safety and comfort
- Before you call for technical support
- Helpful hints
- Solving general problems
- Solving power problems
- Solving hard drive problems
- Solving audio problems
- Solving printer problems
- Solving keyboard and mouse problems
- Solving hardware installation problems
- Solving network problems
- Solving memory problems
- Solving USB flash drive problems
- Solving Internet access problems
- Solving software problems
- Backing up, restoring, and recovering
- POST error messages and diagnostic front panel LEDs and audible codes
- Password security and resetting CMOS
- Power cord set requirements
- Statement of memory volatility
- Specifications
- Index
Webcam
To replace the webcam:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 16).
2. Insert a paper clip into the release holes on each side of the webcam (1) to disengage the internal
latches, and then pull the webcam out of the display head (2).
3. Insert the new webcam into the webcam slot on the display head and press the webcam down so that it
engages the internal latches.
4. Reconnect the power cord and any external devices, and then turn on the computer.
To install a webcam when a webcam blank is installed in the webcam slot on the display head:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 16).
2. Remove the display head rear panel (see Display head rear panel on page 30).
Webcam 31