Installation manual
Table Of Contents
- Safety precautions
- Introduction
- Receive the shipment
- Set up the printer in the final position
- Connect the power cables
- Configure the electrical system
- Purge the ink system
- Prepare the printer
- Prepare for printing
- Prepare the HP Internal Print Server (Japan and Russia only)
- Manually configure the printer’s IP address
- Change the Windows Vista language
HP Scitex Caldera RIP
The HP Scitex Caldera RIP is sold with the HP Scitex LX800/LX600 Printer. After the RIP software has
been installed and the printer has been added to the RIP, use the following procedure to configure the
RIP.
1. Go to the 'Special menu' in the RIP and click on 'Server Admin'.
2. Click on 'Configure' and select the 'Connection' tab, the following screen is displayed. Enter the
IP address of the printer (not the IP address of the IPS).
Install the covers
Manpower Tools Time
1 person T30 screwdriver 5 minutes
66 Chapter 9 Prepare for printing ENWW