Installation manual
Table Of Contents
- Safety precautions
- Introduction
- Receive the shipment
- Set up the printer in the final position
- Connect the power cables
- Configure the electrical system
- Purge the ink system
- Prepare the printer
- Prepare for printing
- Prepare the HP Internal Print Server (Japan and Russia only)
- Manually configure the printer’s IP address
- Change the Windows Vista language
12. Wear gloves and use a cloth to remove the air purgers, as some ink may spill. When you have
finished removing the air purgers, close the carriage cover and access window. Press OK to finish.
13. At this point, check to make sure that the rear ink leakage sensor is correctly placed at the bottom
of the tray (it should be touching the tray).
14. From the front panel, enter the diagnostic menu and select Purge and Setup Menu > Force
Normal Boot .
15. The printer sets the boot configuration.
48 Chapter 7 Purge the ink system ENWW