Installation manual
Table Of Contents
- Safety precautions
- Introduction
- Receive the shipment
- Set up the printer in the final position
- Connect the power cables
- Configure the electrical system
- Purge the ink system
- Prepare the printer
- Prepare for printing
- Prepare the HP Internal Print Server (Japan and Russia only)
- Manually configure the printer’s IP address
- Change the Windows Vista language
●
The pressure sensor gives a negative value. If the pressure is negative, there may be an error
in the ink pressure PCA or in the ink pressure sensor cable. Check both by looking at the
connection of the cable to the ISS PCA and at the pressure sensor PCA. Press OK to cancel
the purge process.
2. If the pressure is positive, probably there is an air bubble inside the cartridge connector tube
column. Prepare the syringe again, then press OK.
3. Insert the same syringe into the ink cartridge and fill it with 20 cc of ink for the color selected.
4. Check that there is no air in the syringe by hitting it a few times. If there is air, hold the syringe
vertically with the needle up, so that the bubble of air rises to the top. Put a cloth around the needle,
and press gently on the piston to remove the air from the syringe.
ENWW 43