Installation manual
Table Of Contents
- Safety precautions
- Introduction
- Receive the shipment
- Set up the printer in the final position
- Connect the power cables
- Configure the electrical system
- Purge the ink system
- Prepare the printer
- Prepare for printing
- Prepare the HP Internal Print Server (Japan and Russia only)
- Manually configure the printer’s IP address
- Change the Windows Vista language
10. Remove the plastic tie securing the spindle and the tape covering the air valve.
11. Remove the ink system compartment strap from the printer.
12. Remove the plastic coverings from the ink cartridge connectors.
13. Remove the intermediate tank plastic bags, foams and straps.
14. Remove the plastic ties securing the tri-phase and single-phase power cables.
15. Remove any other plastic ties that you can see inside the printer.
20 Chapter 4 Set up the printer in the final position ENWW