Installation guide

Chapter 8 Installing the HP NetServer in an HP Rack System/E or Rack System/U
84
Installing Bezel Rack Nuts
Facing the front of the rack:
1. Install the bezel-latch rack nuts on the right front column (holes 11 and 15
up from the baseline).
2. Install the bezel-hinge rack nuts on the left front column (holes 6 and 19 up
from the baseline).
3. Install the Z-bracket rack nuts on the right rear column (holes 9 and 13 up
from the baseline).
NOTE The Z-bracket installation is only required if the NetServer is to
be shipped while installed in a rack. The Z-bracket allows the
NetServer to be secured to the rear rack column.
Top is 8
EIA units from
the baseline.
Baseline
Template
Install the bezel latch
rack nuts at the
11th and 15th holes
up from the baseline
(front right column).
Install the bezel hinge
rack nuts at the
6th and 19th holes
up from the baseline
(front left column).
Install the Z-bracket
rack nuts at the
9th and 13th holes
up from the baseline
(right rear column).
Front
Figure 8-4. Marking the Columns for Rack Nuts