Installation guide

Chapter 7 Installing Additional Processors

Table 7-1. Configuration Switches – CPU Speed

Speed Switch 1 Switch 2 Switch 3 Switch 4

550 MHz ON OFF OFF OFF

600 MHz OFF ON ON ON

650 MHz OFF ON ON OFF

700 MHz OFF ON OFF ON

750 MHz OFF ON OFF OFF

Table 7-2. Configuration Switches S5-S8

Switch Function To Enable

Switch 5 Clear Configuration ON (normally OFF)

Switch 6 Clear Password ON (normally OFF)

Switch 7 Boot Block ON (normally OFF)

Switch 8 Not Used N/A (normally OFF)

NOTE Some processor speeds listed in Table 7-1 may not be

supported. For the latest support information, visit the HP web

site:

http://www.hp.com/go/netserver

Upgrading the Firmware

Load the HP NetServer Navigator CD-ROM and then power on the LH 6000r and

LH 6000. Follow instructions to ensure that the BIOS is up-to-date.

NOTE You are not required to use the HP NetServer Navigator

CD-ROM to reconfigure your system after installing the new

processor. The NetServer detects the additional processors

automatically. However, HP recommends using the HP

NetServer Navigator CD-ROM that comes with the processor

upgrade kit to ensure you have the latest drivers and

information.