Installation guide

Chapter 3 Opening and Closing the HP NetServer
32
4. At the rear of the rack, remove the two screws that connect the Z-bracket
(if present) to the rear of the NetServer.
Remove the
two screws
holding the
NetServer to
the bracket.
Z-Bracket
1
2
3
4
Figure 3-4. Disconnecting the HP NetServer from the Z-Bracket
5. At the front of the rack, pull the NetServer forward from the rack until you
hear the lockout devices engage with a click.
Locking
Latch
Figure 3-5. Slide Mount Locking Latches
CAUTION The NetServer covers are heavy. Support them as you remove
them, and allow room to move them away from the NetServer
and for storage when removed from the NetServer.