Installation guide

Chapter 3 Opening and Closing the HP NetServer
31
Figure 3-2. Removing the HP NetServer LH 6000r Bezel
3. Do not unscrew the entire hinge or bracket from the NetServer. Use a
Torx 25 screwdriver to remove only the four outer screws so that the hinge
and the bracket remain attached to the NetServer chassis as shown in
Figure 3-3.
Top Cover
Right Cover
Bottom Cover
Remove two
screws securing
the NetServer
to the rack.
Remove two
screws securing
the NetServer
to the rack.
Do not remove
two screws
securing the
bracket
to the NetServer.
Do not remove
three screws
securing the
hinge to the
NetServer.
Figure 3-3. Front of LH 6000r - Screw and Cover Locations