Installation guide

Chapter 3 Opening and Closing the HP NetServer
30
Removing the LH 6000r Rack Mount Covers
CAUTION Do NOT operate the NetServer for more than 30 minutes with
any cover (including power supplies and disk drives)
removed. Otherwise, damage to system components may
result due to improper cooling airflow.
1. Extend the anti-tip foot from under the front of the rack or insure that the
anti-tip feature is installed.
WARNING The anti-tip foot must be extended or the anti-tip feature must
be installed to prevent the rack and NetServer from tipping
over, which could damage the NetServer and injure people.
Anti-Tip
Foot
Leveler
Feet
Figure 3-1. Rack Anti-tip Foot
2. Remove the bezel from the front of the NetServer by swinging the bezel
open (past 90 degrees) until it releases from the three posts on the bezel
hinge (see Figure 3-2).