Installation guide

Chapter 2 Controls, Ports, and Indicators
14
Control Description
RESET
Resets the NetServer. This switch may be disabled by Secure
mode.
Secure Mode Switch
and Indicator
Locks system keyboard, monitor display, and control panel to
prevent unauthorized use. Go to the Setup utility security menu
to configure this feature. Secure Mode LED illuminates when
Secure Mode is enabled.
Status screen
Reports system status. For details, see the following section:
"Viewing System Information."
Server Status LEDs
Red
Yellow
Green
Three LEDs -- one red, one yellow, one green -- are on the
right side of the front panel console. They give you a quick
idea of the NetServer’s general health. The signals provided
reflect the most critical pending event in the system.
Red Yellow Green Indicates NetServer Status:
Off Off Off
Main power is off and the NetServer may or may not
be on standby power.
Flashing Off Off Immediate attention required due to a failed
component in the NetServer. The NetServer may not
be fully operational due to this condition. An audible
alarm may also be enabled.
Off Flashing Off Attention required due to a pre-failure condition. This
condition may be caused by a component failure (for
example, a redundant fan or power supply) or an open
access panel that could lead to a critical component
failure, such as a processor module exceeding its
operating temperature. If the failed component is
redundant, the NetServer may still be operating
normally. An audible alarm may also be enabled.
Off Off On The NetServer is operating normally.