Installation guide

Chapter 2 Controls, Ports, and Indicators
13
Power
Switch
Reset
Switch
Power-on
LED
Escape Scroll
Down
Scroll
Up
Status
Screen
Server
Status
LEDs
Secure
Mode
LED
Secure
Mode
Switch
Door reveals this panel
Lock
Enter
Reset
Figure 2-3. Front Panel Console
Table 2-1. Front Panel Console Switch and Indicator Definitions
Control Description
Lock (LH 6000 only)
Locked
Open
Locks system to prevent unauthorized use.
Note that locking and unlocking of the enclosure is reported to
the system event log (SEL).
DC Power Switch
and LED
Turns the NetServer on and off. This switch is under the
protective door on the front panel. Push once to turn on, again
to turn off. As long as the AC power is connected to the
NetServer, standby power is present.
If the LED is steady green, then the NetServer is
powered-up.
If the LED is flashing green, the NetServer is in
a power-save mode.
If the LED is off, but the two-line display has a
message, standby power is present.
If the NetServer is set up to go into power-save mode, the
power switch is depressed; you must press it for more than four
seconds to effect a power down.