Installation guide

147

13 Alternative Rack Mounting

Introduction

This chapter provides the instructions for mounting the HP NetServer in an HP

Systems rack. Figure 13-1 shows the Systems rack.

Leveler

Feet

Slide

Member

NetServer

Handles

Bezel

Hinge

Bar

Nut

Column

Inside Face

Outside

Face

Anti-Tip

Foot

Bezel

Latch

Rack

Template

Figure 13-1. Installation Hardware

If you have the newer HP System/E or System/U racks, go to Chapter 8. If you are

mounting the HP NetServer in a non-HP rack, see the documentation in the

appropriate rack accessory kit.

NOTE The pedestal HP NetServer LH 6000 cannot be rack-installed

without a conversion kit. Contact your HP reseller for

information about the HP NetServer LH 6000 to HP NetServer

LH 6000r Conversion Kit.