Installation guide

Chapter 10 Configuring the HP NetServer
122
5. Enter the password (new or old) in the appropriate field and press Enter.
The password is accepted and the next field just below it,
"Re-Enter New Password: [ ]" or
"Enter New Password: [ ]" is highlighted.
For security reasons, the password does not appear on the screen.
6. If necessary, enter the new password in the field:
"Enter New Password: [ ]" .
7. Enter the new password again in the field:
"Re-Enter New Password: [ ]" .
After re-entering the new password a pop-up menu displays asking you to
confirm your selection.
NOTE To leave the pop-up menu without entering a password, press
the Esc key.
8. Choose Yes and then press the Enter key.
The "Administrator Password is" field changes to "Set" and on the next
boot the HP NetServer will requests a password to access the Setup Utility.
9. If you want a password on boot up, you may skip the field :
"User Password is:"
and go directly to "Network Server Mode" in Step 11.
10. If you want to enter a User Password, use the arrow keys to move to the
field:
"User Password is:"
and repeat Steps 3-7 for the User Password.
11. Use the arrow keys to move to the field:
"Network Server Mode: [Disabled]" .
12. Press Enter to toggle "Disabled" to "Enabled" in the Network Server
Mode field.
Setting this mode to Enabled will cause the HP NetServer to prompt for a
password when booting from a diskette or a CD-ROM, but will not require