Technical information

ManualsBrandsHP ManualsComputer equipmentLH4r - NetServer - 256 MB RAM

100

IBM XSERIES 300

For the latest product & technical information, refer to the Information Sources on pages 2 and 3.Updated 10/02/01

EIDE Configuration Cabling

The xSeries 300 contains two integrated ATA-100 EIDE controllers. One controller is cabled directly to the 24x-10x IDE CD-ROM. xSeries 300 models that ship with a

standard EIDE HDD use the second EIDE controller to attach the standard HDD. This controller supports up to two EIDE HDDs through the use of a two-drop cable.

SCSI Configuration Cabling

xSeries 300 SCSI models contain a single channel, Ultra160 SCSI adapter. A two-drop, 16-bit LVD SCSI cable is attached to the internal connector of this adapter to

support the standard Ultra160 HDD (model dependent). The second drop can be used to attach a second SCSI HDD. In configurations where external SCSI device

attachment is required, a supported SCSI adapter or ServeRAID controller must be installed.

xSeries 300 Internal SCSI Cabling

xSeries 300 Hard Disk Drive (HDD) Storage

Tot al

Internal

Storage

10,000RPM SCSI HDDs 15,000RPM

SCSI HDDs

9.1GB

(00N8207)

18.2GB

(00N8208)

36.4GB

(00N8209)

18.2GB

(19K0658)

0GB Standard on some base models

18.2GB -

(Std on some

models)

-1

27.3GB 1 1 - -

36.4GB - 2 - 2

54.6GB - 1 1 -

72.8GB - - 2 -

This table does not represent all possible HDD configurations.

1. Select a total storage row then add the quantity of HDDs from all columns in an RPM range. Total Internal

Storage listed is within +/- 0.2GB unless otherwise noted.

To t a l

Internal

Storage

7200RPM EIDE HDDs

20.4GB

(P/N 19K4461)

40GB

(P/N 22P7157)

20.4GB (Std on EIDE models) -

40.8GB 1 -

60.4GB - 1

80GB

- 2

This table does not represent all possible HDD configurations. Total Internal

Storage listed is within +/-0.2GB unless otherwise noted.

1. Select a total storage row then add the quantity of HDDs from all columns to

the standard HDD.

2. The xSeries 300 dual integrated EIDE controllers support a maximum of

three IDE devices per machine including one CD-ROM and two IDE HDDs.

3. Requires removal of the standard HDD.