Technical information

180
Server System Rack and Stack Alternatives
Conversion Kits Stacks Standard
Racks
1
Enterprise
Racks
1
09N4300
4Ux20D Tower-to-Rack Kit
37L6858
5Ux24D Tower-to-Rack Kit
21P9593
5Ux24D Tower-to-Rack Kit II
37L6859
8Ux24D Tower-to-Rack Kit
37L6860
8Ux24D Rack-to-Tower Kit
2
28L4705
8Ux28D Rack-to-Tower Kit
3
10L6912 NetBAY3
Stackable Enclosure
36L9701 NetBAY3E
Stackable Enclosure
9306-250
NetBAY25SR
9306-420
NetBAY42SR
9306-421
NetBAY 42SX
9308-42S
NetBAY42ER
9308-42E
NetBAY42EX
Servers
xSeries 200
4
X X X X X X
xSeries 220
4
XXXXXX
xSeries 230 X X X X X X
xSeries 232 X X X X X X
xSeries 240 X X X X X X
xSeries 250 X X X
5
XXX X X
xSeries 300
6
X
7
X X X X X
xSeries 330
6
X
7
XXX X X
xSeries 340 X X X X X
xSeries 342 XXX X X
xSeries 350 X X X X X
xSeries 370
8
XX
5
XXX X X
xSeries 380 X X X X X
1. See the first page of Rack Cabinets and Options section for additional information concerning IBM rack-supported devices.
2. Includes one NetBAY3 stackable enclosure with casters. See IBM NetBAY3/NetBAY3E Stackable Enclosures section for supported devices.
3. Includes one NetBAY3E stackable enclosure with casters. See IBM NetBAY3/NetBAY3E Stackable Enclosures section for supported
devices.
4. Rack installation requires appropriate Conversion Kit.
5. A maximum of three NetBAY3 or NetBAY3E enclosures may be stacked beneath a supported system unit. NetBAY3 and NetBAY3E
enclosures are shipped separately and not while attached to the server system unit.
6. Blank filler panels (P/N 94G6670) should be placed on the front of any unused rack space to aid proper airflow through the x300 and x330
system units. If non-IBM racks are used, assure that both the front and rear doors offer a minimum of 45% open area uniformly distributed and
in line with the installed servers. A clearance of at least 51mm (2in) must be maintained between the front door and the system unit’s front
bezel. The rear door must maintain the same or greater clearance. Nonrack or NetBAY3 installations are not supported.
7. Up to three xSeries 300s or 330s may be installed inside a NetBAY3E stackable enclosure when a supported server is installed at the top of
the enclosure.
8. Stand-alone tower installation requires appropriate Conversion Kit.