Specifications

Chapter 5 Installation and Configuration
42
Step D. Install the Adapter
In this step, you will:
• Turn off the HP Netserver and remove the necessary covers or open the
panels
• Install the adapter
Turn Off the HP Netserver and Open It
CAUTION HP NetRAID-1M and 2M Accessory boards are not hot
pluggable. Unplug HP Netserver power cord(s) before
installing a HP NetRAID-1M or 2M board.
NOTE Before you begin, you may need to look up information about
your HP Netserver in Information Assistant on the
HP Netserver Online Documentation CD-ROM. You will need
to know how to open or remove the HP Netserver panels and
covers, as well as any special instructions for installing a
board in a PCI slot of the HP Netserver.
Turn off the HP Netserver and open it, as follows:
1. Bring down the operating system properly, as described in your
NOS documentation.
2. Turn off the HP Netserver power and disconnect the power cord(s) and all
telephone cords.