Specifications

Chapter 9 Managing Servers Over the Network
117
Novell NetWare Server Installation Instructions
NOTE All NetWare servers that contain HP NetRAID-1M or
2M adapters that will be managed by HP NetRAID
Assistant must be running the same version of NetRAID
Software—NetWare. Be sure to update any existing
installations.
The client or server managing these HP NetRAID
adapters must be running HP NetRAID Assistant version
A.02.02 or newer.
For each server operating under Novell NetWare and containing an integrated
HP NetRAID controller or HP NetRAID-1M or 2M adapter to be managed over
the network, install NetRAID Software—NetWare as follows:
1. For NetWare 4.2 only, the file
rpcbstub.nlm is a read-only file. This
file attribute must be changed to read/write before installing the NetRAID
Software—NetWare on a client connected to NetWare through the
network. Exit to the DOS prompt and change the file attribute to r/w with
the
attrib command. The file is located in the \system\ directory of
NetWare on the
SYS volume.
2. Start the NetWare server and insert the "NetRAID Software—NetWare"
diskette.
3. At the NetWare console prompt, type
load a:\raidinst.nlm
4. Choose Install Package.
5. To the question "Install registration server?" select yes or no.
◊ Select yes if you want this server to be the Registration Server.
◊ Select no if this server will not be the Registration Server. Enter the
name of the Registration Server when prompted.
6. Files are copied.
NOTE For NetWare 4.2, if you get the error message "Not able
to create SYS:SYSTEM\RPCBSTUB.NLM," go back to
Step 1 and change the file attribute to r/w.