Service manual

Chapter 6 Replacing Parts
72
Removing the Bezel – Rack Mount
Remove the bezel from the front of the NetServer by swinging the bezel open (past 90 degrees) until it
releases from the three posts on the bezel hinge.
Removing the HP NetServer LH 3000r Bezel
Replacing the Bezel – Rack Mount
Replace the bezel by holding the bezel at 90 degrees to the left side of the NetServer. Snap the bezel
clamps onto the hinge posts by pressing the bezel onto the hinge. When the bezel is snapped into place,
swing the bezel closed.
Removing the Bezel – Pedestal
1. Unlock the bezel, using the supplied key.
The bezel connects to the chassis with two snap-in connectors inside its top left and right
corners and two tabs that fit into two slots on the bottom of the chassis.
2. Remove the bezel.
a. Pull bezel toward you until it unsnaps.
b. Lift the bezel forward and upward from the chassis face.