Manualshelf

Service manual

ManualsBrandsHP ManualsPrint & ScanLH3000r - NetServer - 128 MB RAM
41424344454647484950
Chapter 4 Diagnostics
42
4. If the problem persists, your CD-ROM drive may need to be replaced. Contact your service
representative.
0401 The CD-ROM drive is not responding but is configured in the Setup utility.
1. If the CD-ROM drive has just been removed, press [F4] to automatically validate the change.
2. Check that all data cables and power cables are firmly connected.
3. If the cable is damaged, connect the hard disk drive to another IDE cable, if available.
4. If the problem persists, your CD-ROM drive may need to be replaced. Contact your service
representative.
0500 The system board self-test has detected a general failure on the integrated hard disk controller.
Your system board may need to be replaced. Contact your service representative.
052X The specified hard disk drive is not responding but is configured in the Setup utility.
1. If the specified hard disk has just been removed, press [F4] to automatically validate the
change.
2. Check that all data cables and power cables are firmly connected.
3. If the cable is damaged, connect the hard disk drive to another IDE cable, if available.
4. If the problem persists, your hard disk drive may need to be replaced. Contact your service
representative.
Error codes #0520, #0521, #0522, #0523 respectively apply to HDD0, HDD1, HDD2, and HDD3 as
described in the Setup utility.
0076 The processor for the Integrated HP NetRAID is not responding.
This problem will prevent the operation of the Integrated HP NetRAID, if it is enabled. The problem may also
prevent operation of some PCI slots.
To correct this problem:
Flash the integrated HP NetRAID firmware and reboot the system.
If the error persists, your I/O board may need to be replaced. Contact your service representative.
0080 The NetServer Management Controller failed its self-test.
Due to this failure remote access and server management event logging are not available.
To correct this problem:
Reset the management controller by powering off the NetServer and disconnecting the power cord for 20
seconds. Reconnect the power cord and power on the NetServer.
OR
Update the system BIOS by running the flash utility from the Navigator CD-ROM.
0600 The video memory size detected during the power-on self-test is smaller than previously detected.
1. If the video memory module has just been removed or replaced by a smaller one, press [F4] to
automatically validate the change.