Service manual

Chapter 4 Diagnostics
40
configure your system.
0020 The ROM on the accessory board is either bad, or the board is conflicting with a system board reserved
resource (address, DMA or IRQ).
0070 The Smart Interrupt Router FPGA failed to initialize. This problem prevents your system from booting and
operating. If the error persists, replace the system board.
0071 The data for the Smart Interrupt Router FPGA is corrupted. This problem prevents your system from
booting and operating. If the error persists, try re-flashing the system BIOS before replacing the system board.
See the recovery boot procedure.
0075 The firmware for the Integrated HP NetRAID is not responding. This problem prevents the operation of the
Integrated HP NetRAID.
To correct this problem, flash the Integrated HP NetRAID firmware and reboot the system.
If the error persists, replace the I/O board.
0080 The HP NetServer Management Controller failed its self-test.
Due to this failure remote access and server management event logging are not available.
• To correct this problem reset the Management Controller by powering off the HP NetServer and
disconnecting the power cord for 20 seconds. Reconnect the power cord and power on the HP
NetServer.
OR,
• Update the system BIOS by running the flash utility from the HP Navigator CD-ROM. To do this,
insert the HP Navigator CD-ROM in the CD-ROM drive and power-cycle your system.
If the error persists, your system board may need to be replaced. Contact your service representative.
0090 The DIMM Management Controller has failed to respond.
This does NOT affect the performance or functionality of the memory. However, due to this failure DIMM
management features are not available.
To correct this problem reset the Management Controller by powering off the HP NetServer and
disconnecting the power cord for 20 seconds. Reconnect the power cord and power on the HP NetServer.
If the error persists, your system board may need to be replaced.
0100 A key on the keyboard has been pressed during the HP NetServer power-on self-test.
1. Ensure that nothing was put on the keyboard during boot process, and that a key was not
accidentally pressed down.
2. If the error persists, your keyboard may need to be replaced. Contact your service
representative.
0101 The keyboard has reported an error during its self-test.
1. Restart your HP NetServer.
2. If the error persists, your keyboard may need to be replaced. Contact your service
representative.