Service manual

Chapter 1 General Information
5
1
2
3
4
Remove the
two screws
holding the
NetServer to
the bracket
Z-BracketZ-Bracket
Remove Z-bracket
5. The z-bracket is used only during shipment to secure the NetServer to the rack. To remove the
z-bracket, remove the two screws that connect the z-bracket to the column at the rear of the
NetServer. Save the z-bracket for future use.
6. At the front of the NetServer, pull the NetServer forward from the rack until you hear the lockout
device engage with a click.
Locking
Latch
Locking Latch
CAUTION The HP NetServer covers are heavy. Support them as you remove them, and allow
room to move them away from the HP NetServer and for storage.
7. Remove Cover 1 by loosening the thumbscrew and sliding the cover forward to disengage it. Lift
it up and away from the chassis.