Service manual

Chapter 6 Replacing Parts
103
9. Install all components on the new system board.
10. Install the system board assembly in the chassis.
Install the System Board Assembly
CAUTION Do not operate the HP NetServer for more than sixty minutes without first installing
all covers and the front bezel. Operating the system without all covers in place
reduces critical cooling airflow over some components, such as hard disk drives and
processors. Operating the system without all covers in place may result in failure of
these components.
11. Replace the covers and bezel.
12. Reconnect the power cords and signal cables.
13. Return the NetServer to normal operation.
14. Reset the system time and date if necessary.