Service manual

Chapter 6 Replacing Parts
97
Power Supply
Status LEDs
Power
Supplies
Power
Connectors
1
2
3
4
Thumbscrews
Handles
LH 3000 Power Supply Location
2. Remove the AC power cable from the inlet on the supply.
3. Grasp the handle on the power supply.
4. Pull the power supply out of the NetServer chassis.
5. Slide the replacement power supply into the chassis.
6. Once the power supply is seated in the chassis, use a T15 driver to tighten the thumbscrews.
7. Check the status LED.
Replacing Power Supply Fans
The power supply fans may be hot swapped. Note that the air baffles adjacent to them must be properly
seated to allow the side panel to go back on.
Power
Supply
Fan
Assembly
Air Baffles