Service manual

Chapter 6 Replacing Parts
96
Replacing PCI Slot Dividers
The PCI slot dividers simply snap in and out of plastic mounting fixtures on the I/O board. However, you may
have to remove the PCI card guide to get a replacement slot divider into the chassis. Refer to the following
figure.
Slot divider
I/O Fans
PCI Card Guide
Card Guide Retainer
Note, to remove the
card guide, swing
the outside end
to the front of the NetServer..
Replacing the Power Supplies
Check the power supply status LEDs before removing and replacing the supply.
CAUTION If a power supply bay is not in use; be sure to keep the cover on it. If you do not,
system ventilation and EMI (electro-magnetic interference) suppression may be
affected.
1. Locate the power supply to be removed.
NOTE If the NetServer is powered on and the status LED for a seated supply is off, you
may infer that the supply has failed. However, when the NetServer is in standby
(plugged in but powered-down; front panel LCD is ON), the power supply status
LEDs will be OFF.