Service manual

Chapter 1 General Information
4
Removing the HP NetServer LH 3000r Bezel
3. Use a Torx 15 screwdriver to unscrew the four screws.
4. Do not unscrew the entire hinge or bracket from the HP NetServer. Remove only the outer
screws so the hinge and the bracket remain attached to the NetServer chassis.
Cover 1
Cover 2
Cover 3
Remove two screws
Securing the Netserver
to the rack.
Do not remove the
three screws securing
the hinge to the Netserver.
Do not remove the
two screws securing
the bracket to the
NetServer.
Remove the two
screws securing
the NetServer to
the rack.
Front of LH 3000r Screw and Cover Locations