Installation guide

Chapter 3 Opening and Closing the HP NetServer
32
Cover 1
Cover 2
Cover 3
Remove two screws
Securing the Netserver
to the rack.
Do not remove the
three screws securing
the hinge to the Netserver.
Do not remove the
two screws securing
the bracket to the
NetServer.
Remove the two
screws securing
the NetServer to
the rack.
Figure 3-4. Front of LH 3000r Screw and Cover Locations
1
2
3
4
Remove the
two screws
holding the
NetServer to
the bracket.
Z-BracketZ-Bracket
Figure 3-5. Remove Z-bracket
5. The z-bracket is used only during shipment to secure the NetServer to the
rack. To remove the z-bracket, remove the two screws that connect the
z-bracket to the column at the rear of the NetServer. Save the z-bracket for
future use.