Installation guide

Chapter 2 Controls, Ports, and Indicators
12
Front Panel Console
Figure 2-3 shows the HP NetServer LH 3000’s Front Panel Console (the HP
NetServer LH 3000r is similar, but has no lock).
Power
Switch
Reset
Switch
Power-on
LED
Escape Scroll
Down
Scroll
Up
Status
Screen
Server
Status
LEDs
Secure
Mode
LED
Secure
Mode
Switch
Door reveals this panel
Lock
Enter
Reset
Figure 2-3. Front Panel Console
Table 2-1. Front Panel Console Switch and Indicator Definitions
Control Description
Lock (LH 3000 only)
Locks system to prevent unauthorized use.
Note that locking and unlocking of the enclosure is reported to
the system event log (SEL).
DC Power Switch
and LED
Turns the HP NetServer on and off. This switch is under the
door on the front panel. Push once to turn on, once more to turn
off. As long as the AC power is connected to the HP
NetServer, standby power is present.
If the LED is steady green, then the HP
NetServer is powered-up.
If the LED is flashing green, the NetServer is in
a power-save mode.
If the LED is off, but the two-line display has a
message, standby power is present.
To go into power-save mode, depress the power
switch; you must press it for over four seconds
to effect a power-down.