Installation guide

Chapter 1 Setting Up the HP NetServer LH 3000r and LH 3000
6
10. Replace covers and the bezel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
11. Connect the monitor, keyboard, mouse and power supplies.
Refer to Chapter 9, "Connecting Monitor, Keyboard, Mouse, and Power
Supplies."
12. Connect external cables.
13. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
Go to the next section, "Configuring the HP NetServer."
Configuring the HP NetServer
Document
Number
X
X
X
X
Figure 1-4. Navigator CD-ROM
1. Load the HP Navigator CD-ROM. Place the HP NetServer Navigator
CD-ROM in the drive and close the drive.
NOTE To fully configure the HP NetServer, all the rack components
must be cabled and online (though not necessarily installed in
the rack).
Refer to Chapter 10, "Configuring the HP NetServer."