HP Mini 210 - Maintenance and Service Guide (Consumer Models Only)

Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 33).
b. Service access cover (see
Service access cover on page 36).
c. Hard drive (see
Hard drive on page 39).
d. Keyboard (see
Keyboard on page 48).
e. Display assembly (see
Display assembly on page 57).
5. Disconnect the WWAN antenna cables from the WWAN module (see
WWAN and GPS modules
(select models only) on page 42).
6. Disconnect the WLAN antenna cables from the WLAN module (see
WLAN module on page 44).
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
SIM (see
SIM on page 35)
●
WWAN module (see
WWAN and GPS modules (select models only) on page 42)
●
WLAN module (see
WLAN module on page 44)
●
Memory module (see
Memory module on page 46)
●
RTC battery (see
RTC battery on page 47)
●
Fan/heat sink assembly (see
Fan/heat sink assembly on page 61)
64 Chapter 4 Removal and replacement procedures