- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
LCS60 Software
Configure Protocols and Gateway Services — srvsetup
Enter Menu Selection
[ Type q to QUIT or ? for HELP ]
==> 1
Enter session parameter:
"maxsessions", "ppp", "slip", "arap", "asytcp", "tcpasy"
[ Type q to QUIT or ? for HELP ]
==> ppp
Enter session parameter value
[ Type q to QUIT or ? for HELP ]
==> 90
NOTICE: Entering < ppp > service with value of < 90 >
Is this correct?
Enter y,n ==> y
CAUTION: Please refer to the I&A Guide for instructions
about configuring this feature.
LCS60 AND SERVICE SESSION PARAMETER CONFIGURATION MENU
1. Add/Change a Session Parameter
2. Delete a Session Parameter
3. Display all Session Parameters
Enter Menu Selection
[ Type q to QUIT or ? for HELP ]
==> 1
Enter session parameter:
"maxsessions", "ppp", "slip", "arap", "asytcp", "tcpasy"
[ Type q to QUIT or ? for HELP ]
==> asytcp
Enter session parameter value
[ Type q to QUIT or ? for HELP ]
==> 120
NOTICE: Entering < asytcp > service with value of < 120 >
Is this correct?
Enter y,n ==> y
CAUTION: Please refer to the I&A Guide for instructions
about configuring this feature.
LCS60 AND SERVICE SESSION PARAMETER CONFIGURATION MENU
1. Add/Change a Session Parameter
2. Delete a Session Parameter
3. Display all Session Parameters
Enter Menu Selection
Issue 3 3-13