- Hewlett-Packard User Guide Printer LCS60

LCS60 Software
Configure Protocols and Gateway Services —
srvsetup
After executing the initial setup procedures above, configure the protocols and
gateway services using the srvsetup command (Figure 3-3).
Figure 3-3: srvsetup
configure protocols/services
srvsetup
protocol
maxsessions
select protocols and services:
asytcp, tcpasy, etc.
assign the maximum
number of sessions to
each protocol and service
etherif
configure the ethernet
interface
atalkas
ipas ipx
Note: The configuration activities in the srvsetup command (protocol,
maxsessions, ipas, ipx, atalkas, etherif) can also be accessed
individually. Refer to Chapters 4, 5, 6, and 7 for examples of individual
commands.
Perform the following steps to configure the protocols and gateway services for
your LCS60. (You should have already done an initsetup as described
previously.)
Step 1 Enter srvsetup at the Top>Config># prompt to start the
protocol/service setup routine.
Step 2 Follow the menus in the srvsetup; they will guide you through the
items essential for your configuration (refer to Figure 3-3). A sample
srvsetup session is presented in the screens that follow.
Note: Refer to the Glossary at the end of this document for definitions of
parameter values.
3-10 Issue 3