- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Hardware
Installing the LCS60
2 . Connect the LCS60 rear panel connector labeled "Serial Port 1" to an asyn-
chronous port on the data switch using a straight-through connection
(D8AH connector); connect the 25-pin end to the LCS60.
3 . Configure the asynchronous port on the data switch according to Table
2-4 as a receiving group. Conduct the dialogue shown in Screen 2-1 (TY-
12) or Screen 2-2 (MSM) on the data switch console to:
a . Configure a group on the data switch network for the asynchronous port
connected to the LCS60
b . Configure a name pointing to this group which can be used to access the
LCS60 console port.
Refer to the appropriate Lucent Technologies data switch Node Reference
Guide for complete instructions.
4 . Restore the asynchronous port and name to service.
5 . Log on to StarKeeper II NMS; execute dkcu to the call address created for
the LCS60 console. Maintain proper security precautions to guard against
unauthorized or accidental usage.
6 . Continue with the Connecting Fiber Interface section.
Figure 2-6: System Console Connections – through StarKeeper II NMS
Asynchronous
Terminal
StarKeeper
II NMS
Data
Switch
CPM-HS
Asynchronous
Port
DCE
Console
Port
LCS60
2-18 Issue 3