- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Hardware
Installing the LCS60
Connection through Modems
To connect an asynchronous terminal or PC to the LCS60 for use as a system con-
sole by means of modems, refer to Figure 2-5 and follow the steps below:
1 . Option Serial Port 1 to emulate DTE operation. (Refer to the section Serial
Port Optioning earlier in this chapter.)
2 . Connect the LCS60 rear panel connector labeled "Serial Port 1" to an asyn-
chronous terminal by means of modems using straight-through RS-232
cabling. Modems must operate asynchronously at 9600 bps.
3 . Power up the system console and set options as directed in Table 2-4.
4 . Continue with the Connecting Fiber Interface section.
Figure 2-5: System Console Connections – through Modems
Asynchronous
Terminal
Modem
Modem
DTE
Console
Port
LCS60
Connection through StarKeeper II NMS
For the StarKeeper II NMS connection (Figure 2-6), follow the steps below:
1 . Serial Port 1 should be optioned to emulate DCE operation. This is the
default; therefore, if you haven’t changed anything there will be no need
to change the option.
Issue 3 2-17