- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Hardware
Installing the LCS60
Note: There are small variations in system prompts and responses depending
on the release of the Lucent Technologies data switch (Datakit II VCS or
BNS).
4 . Power-up the system console terminal or PC and set the options as
directed in Table 2-4.
5 . Connect an asynchronous terminal or PC to an asynchronous port on the
data switch, using a null-modem connection (D8AG connector). A gender
changer may be required depending on the type of RS-232 connector
available on the terminal device. Configure the asynchronous port
according to Table 2-4 as an originating group. Refer to the appropriate
Lucent Technologies data switch Node Reference Guide for complete
instructions.
6 . Restore both asynchronous ports and name to service.
7 . In response to the DESTINATION prompt on the terminal device, enter the
name created for the LCS60 console. This step can be done from any ter-
minal displaying a DESTINATION prompt. Maintain proper security pre-
cautions to guard against unauthorized or accidental usage.
8 . Continue with the Connecting Fiber Interface section.
Figure 2-4: System Console Connections – through a Data Switch
Asynchronous
Terminal
Data Switch
Asynchronous
Port
DCE
Console
Port
LCS60
2-16 Issue 3