- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Hardware
Installing the LCS60
Table 2-6: RS-232 Interface
_ __________________________________________________________________
Pin Designation Function Direction
_ __________________________________________________________________
Port 1 2 BA TD-Transmit Data To DCE
3 BB RD-Receive Data From DCE
Async DTE 4 CA RTS-Request To Send To DCE
5 CB CTS-Clear To Send From DCE
Emulation 7 AB Signal Ground
20 CD DTR-Data Terminal Ready To DCE
_ __________________________________________________________________
Pin Designation Function Direction
_ __________________________________________________________________
Port1 2 BA TD-Transmit Data From DTE
3 BB RD-Receive Data To DTE
Async DCE 4 CA RTS-Request To Send From DTE
5 CB CTS-Clear To Send To DTE
Emulation 6 CC DSR-Data Set Ready To DTE
7 AB Signal Ground
8 CF DCD-Data Carrier Detect To DTE
_ __________________________________________________________________
Pin Designation Function Direction
_ __________________________________________________________________
Ports 2, 3, 2 BA TD-Transmit Data To DCE
3 BB RD-Receive Data From DCE
and 4 4 CA RTS-Request To Send To DCE
5 CB CTS-Clear To Send From DCE
Async DTE 7 AB Signal Ground
8 CF DCD-Data Carrier Detect From DCE
Emulation 20 CD DTR-Data Terminal Ready To DCE
_ __________________________________________________________________
Pin Designation Function Direction
_ __________________________________________________________________
Ports 2, 3, 2 BA TD-Transmit Data From DTE
3 BB RD-Receive Data To DTE
and 4 4 CA RTS-Request To Send From DTE
5 CB CTS-Clear To Send To DTE
Async DCE 6 CC DSR-Data Set Ready To DTE
7 AB Signal Ground
Emulation 8 CF DCD-Data Carrier Detect To DTE
20 CD DTR-Data Terminal Ready From DTE
_ __________________________________________________________________
_ __________________________________________________________________
Issue 3 2-11