- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Hardware
Installing the LCS60
2 . With the horizontal support in place, slide the LCS60 into place. Fasten
the front frame of the LCS60 to the front uprights with four screws (23- or
25-inch cabinets require extension brackets).
Figure 2-1: Mounting the LCS60 Cabinet
LCS60 mounts inside
Wall Mount Assembly
Wall Mount Assy.
mounts to wall
Disk and tape drives
must be on top
TOP
WALL
WALL MOUNT
TABLE TOP MOUNTRACK MOUNT
Horizontal shelf,
slide rails, or
support brackets
required
Cabinet
Rear uprights
Cabinet
Front Uprights
Front
Front
Frame
. .
. .
. .
. .
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
. . . . .
BOTTOM
Issue 3 2-7