- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Table of Contents
Dialogues 2-22
Enter Group Name 2-22
Define the Local Address for the LCS60 2-22
Configure the CPM-HS Module 2-24
Power and Grounding 2-25
Power-Up Procedures 2-25
Power-Down Procedures 2-27
Verify LCS60 Console Connection 2-27
Verify Fiber Connection 2-28
Configure the LCS60 2-29
LAN Connections 2-29
Ethernet 2-29
3
General LCS60 Software Configuration
Introduction 3-1
Preliminary Hardware Requirements 3-1
Preliminary Configuration Requirements 3-2
Specific Services 3-3
Initial Setup 3-3
Configure Protocols and Gateway Services —
srvsetup 3-10
Configure Default Route, DNS, and SNMP 3-23
Default Route – dftroute* 3-24
Domain Name Server – dns 3-25
SNMP Manager – snmp 3-26
Starting the LCS60 3-27
Base Level Backup 3-27
Configuration Changes 3-28
Administrative and Maintenance Commands 3-29
4
PPP – Configuration and
Administration
LCS60 Configuration and Connection for PPP Service 4-1
PPP Service Connection Dialstrings 4-13
Privately Administered Static IP Address 4-15
Reserved IP Address 4-16
Issue 2 iii