- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Hardware
Introduction
The LCS60 is supplied with the operating software already installed; therefore,
installation consists mainly of installing hardware and configuring the system.
The list below identifies the tasks, in the order that they should be performed, to
install and configure the product. These tasks are discussed in detail in the fol-
lowing sections.
1 . Mount the LCS60
2 . Attach the console to the LCS60
3 . Connect the fiber between the LCS60 and the CPM-HS
4 . Configure the LCS60 in the data switch
5 . Power-up the LCS60
6 . Verify the LCS60 console connection
7 . Verify the LCS60 fiber connection
8 . Configure the LCS60 using the lcsadm interface (Chapters 3–7)
9 . Verify connections between the LCS60 and LAN hosts and between the
LCS60 and data switch connected endpoints (Chapter 9).
Controls and Indicators
Table 2-1 lists the LCS60 controls and indicators.
Issue 3 2-1