- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Features
Manual Pages
The LCS60 is provided with a set of online manual pages. Some commands that
may be of particular help to the system administrator are listed in Table 1-1 and
are included in Appendix E.
Table 1-1: Online Manual Pages
_ _______________________________________________
Protocol Commands Path
_ _______________________________________________
General dkcu /opt/dk/bin/dkcu
dkmaint /opt/dk/sbin/dkmaint
ifstat /usr/bin/ifstat
iftrace /usr/etc/iftrace
push /usr/bin/push
pull /usr/bin/pull
statlcs /usr/etc/statlcs
_ _______________________________________________
TCP/IP ftp /usr/etc/ftp
ifconfig /usr/etc/ifconfig
netstat /usr/etc/netstat
nslookup /usr/etc/nslookup
ping /usr/etc/ping
route /usr/etc/route
telnet /usr/etc/telnet
_ _______________________________________________
AppleTalk atlog /usr/etc/atlog
atping /usr/etc/atping
atnetstat /usr/etc/atnetstat
_ _______________________________________________
IPX ipxping /usr/etc/ipxping
ipxnetstat /usr/etc/ipxnetstat
_ _______________________________________________
_ _______________________________________________
The commands dkmaint and ifconfig are not used in normal LCS60 operations,
and should only be used by expert users and system administrators. These com-
mands are not recommended except for troubleshooting purposes.
Access online man pages by executing the command:
Issue 3 1-21