- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Glossary
Glossary
Class Equals 1; dial-in server.
Imp ID Implementation ID: V<major version>.<minor version>.
Name Name of the server (LCS60).
AT Comp AppleTalk compression type. (Not supported.)
Route Proto Routing protocol. (Not supported.)
Broadcast
Supp
Broadcast packet suppression. (Not supported, therefore, no
packets are suppressed.)
Address (ipx) IPX network number and node number.
Router
Name (ipx)
The IPX router (the LCS60) for the virtual network.
CIPX Max
Slot (ipx)
Indicates whether CIPX compression is being used or not (0). If
used, the number is the maximum number of slots.
Route Proto
(ipx)
Routing protocol to exchange. (Not supported.)
Trace ARAP
Top>Session> trace arap
Sesid Session ID number.
Name The name of the ARAP session. This name will be the letter
a followed by the data switch channel number.
Remote Addr –
Zone
The zone name of the virtual AppleTalk network assigned to
the LCS60.
Remote Addr –
Address
The network and node number assigned to this session.
Issue 3 G-13