- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Glossary
Glossary
Recv(Pkts) Number of packets received.
Receive Errors
Len Indicates the length of the PPP frame received was not valid.
CRC Indicates a checksum error for the PPP frame received.
State Indicates that the state of the PPP frame received was invalid for
HDLC framing.
Alloc Indicates that the system was unable to allocate a buffer for the
received frame.
Show PPP – Link, IP, IPX, AppleTalk
Top>Session> show ppp link, ip, ipx, atalk
Note: Many of the report fields refer to features that are configured on the PPP
host with the particular PPP package you are using. Refer to the docu-
mentation for your particular PPP package for details.
Sesid Session ID number.
State The state of the session (opened, closed, init, starting, etc.).
Max Config The number of times the LCS60 will try to configure a connec-
tion before quitting.
Max Term The number of times the LCS60 will try to terminate the link to
the PPP host gracefully before dropping the connection.
Timeout Secs The number of seconds the LCS60 will wait for a response to a
configure or terminate request from the peer before timing out.
S Side of the PPP link (p peer or l local).
MRU Maximum receive unit (refer to the documentation for the PPP
package you are using).
Issue 3 G-11